 |
|
|
|
[How To] Doublepeg Grind
by Chemist | 26 Aug 2005 1:50 pm
Trick Description:
Bunnyhop on an object and grind with both pegs at the same time
HOWTO:
good, but I know how to do them and ride out clean. So here it is with pictures. (Mind the pictures I had a dirty lense over my camara filter so they look really dirty.)
First, you ride into it with good speed. Don't even try going very slow.
2. You begin to hop while parallel to the rail/slope.
3. Try to pull the handlebar high enough for a good hop
4. You lean towards the rail in the hop so that the bike falls into the rail and make sure you get your back peg on. Although, it doesn't hurt if you miss. I've never actually hurt myself harshly grinding.
5. Push down on your front fork so that your front peg is touching against the rail.
6. As you begin to grind don't be afraid of the fall because even if you do fall or whipe out, it usually doens't hurt. Balance isn't really that much of an obstacle, in my point of view you don't have to balance at all, it just comes naturally.
7. Turn your front wheel opposite of the rail so that you fall out and land. (This gives you a smooth landing.) You can also hop out using the same method except hopping away from the rail.
These are the last few pictures.
I hope you like this Doublepeg Grind How To 
Seite 1/1
Dieser Artikel wurde bereits 26924 mal gelesen
Kommentare
Eigenen Artikel veröffentlichen
|
|
|
|
|
|
|
|
