Hi, in this how-to I will show you how to make ghetto hubguards. First of all you will need a plastic roll thing,
like this:



You will need these tools:



Step 1.

Take you roll and put it in a vice and start sawing, and make sure that it will fit.
(I know that I already sawed one side of, sorry)



Sometimes there is a wire left in there, just cut it of.


Step 2.

Now you are almost done,
cut away all whats left in the middle so you can slide it on smoothly.



Once you have done that just slide it on you cone spacer and you are ready to go!

Page 1/1
This article has been read 2816 times

Comments

Publish your own Article